| II
- Forgings / Fabricated Items |
Action By |
| 1. |
a. |
Transfer code no. of pipes on each part pcs of
the particular length of pipe to be used for fabricated
pipes, tees and plain forgings. |
Sub Contractor |
| |
b. |
Fill the pipe code stamp transfer report accordingly. |
Sub Contractor |
| |
PN – XXX Within 300 mm from fixed flange for lined
pipe. |
|
| |
For
Elbow at center |
|
| |
For
Tee at center |
|
| |
For
Reducer at ¼ of the length |
|
| 2 |
Punch Lot No. on the plain forgings. Re-punch pipe
code no. if it is distorted during forging. |
|
| |
F
XXX PN - XXX |
|
| 3 |
Punch Identification No. on the fabricated items
as follows |
Sub Contractor |
| |
For Pipe: At O.D. surface of fixed flange after Lot No./ Machinist
/ Flange Inspector’s punch |
|
| |
For Tee: At O.D. surface of TCF and BCF after Lot No. / Machinist
/ Flange Inspector’s punch |
|
| |
For Elbow: At O.D. surface of fixed flange after Lot No. / Machinist
/ Flange Inspector’s punch |
|
| |
For Reducer: At O.D. surface of bigger size flange after Lot No. /
Flange /Inspector’s punch |
|
| 4 |
Punch last 4 digits of set no. on the fabricated
items after identification no. punch |
Sub Contractor |
| 5 |
Punch clients part no.,if it is there on the fabricated
items as follows |
Sub Contractor |
| |
For Pipe: Below pipe code no. |
|
| |
For Tee: Below pipe code no. on main body |
|
| |
For Elbow/ Reducer: Below forging lot no./ pipe code no. |
|
| |
For Instrument Tee: Below pipe code no. at branch body |
|
| 6 |
Fill Traceability report for fabricated items |
Sub Contractor |
| 7 |
Punch Inspector’s Stamp as follows: - |
|
| |
| a. |
For Forgings |
At O.D. surface after pipe code no. punch. |
| b. |
For Fabricated items |
At O.D. surface off flanges as mentioned in above sr.
no. 3 after set no. punch or after keeping gap of 4 digits
for set no.
(for stock items i.e. when set no. is not
available) |
|
Sub Contractor in presence of inspector |
| 8 |
Submit Pipe Code Stamp transfer report and traceability
report along with challan approved by Inspector |
Sub Contractor |
| Note:
Punch size: For identification No. it is 8 mm and for
other details it is 5mm |
Anti - Corrosion Products
The long term success of any
company is determined by the durability of its product. At
Fluoropolymer our mission is to provide quality solutions
that enable continuos cost-effectiveness and improvements.
Our stringent quality checks are in keeping with ISO regulations.
Our goal is to provide you with products you can rely on to
fulfill your project and maintenance requirements.
QUALITY ASSURANCE PROCEDURE
